Dell PowerEdge R720 and R720xd Owner's Manual

Installing The I/O Panel (PowerEdge R720xd)

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.

If installed, remove the front bezel.
Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
Open the system.
Fold the label around the cable.
Push the cable until the cable passes completely through the channel.
- CAUTION: To prevent damage to the I/O cable, you must release the locking tab before removing or installing the I/O cable from the connector on the hard-drive backplane.
If locked, rotate the locking tab on the I/O cable connector clockwise 90 degrees to release the lock.
Connect the I/O panel cable to the connector on the hard-drive backplane.
Rotate the locking tab on the I/O cable connector counter clockwise 90 degrees to secure the lock.
Tighten the three Torx screws to secure the control panel to the chassis.
- NOTE: You must route the cable properly to prevent it from being pinched or crimped.
Close the system.
Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
If applicable, install the front bezel.