- Notes, cautions, and warnings
- Dell PowerEdge T30 system overview
- Documentation resources
- Technical specifications
- Initial system setup and configuration
- System Setup
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- System cover
- Bezel
- Inside the system
- Power switch
- Chassis intrusion switch
- Input/Output (I/O) panel
- Hard drives
- Removing the hard drive cage
- Installing the hard drive cage
- Removing a 3.5-inch hard drive carrier from the hard drive cage
- Installing a 3.5-inch hard drive carrier in the hard drive cage
- Removing a 2.5-inch hard drive(s) from the optical drive bay
- Installing a 2.5-inch hard drive(s) in the optical drive bay
- Removing a 3.5-inch hard drive carrier from the hard drive bay
- Installing a 3.5-inch hard drive carrier in the hard drive bay
- Removing a hard drive from a hard drive carrier
- Installing a hard drive into a hard drive carrier
- Optical drive
- System memory
- System fan
- Expansion cards
- Processors and heat sinks
- Power supply unit
- System battery
- System board
- Using system diagnostics
- Jumpers and connectors
- Troubleshooting your system
- Minimum to POST
- Troubleshooting system startup failure
- Troubleshooting external connections
- Troubleshooting the video subsystem
- Troubleshooting a USB device
- Troubleshooting a serial input and output device
- Troubleshooting a NIC
- Troubleshooting a wet system
- Troubleshooting a damaged system
- Troubleshooting the system battery
- Troubleshooting power supply units
- Troubleshooting cooling fans
- Troubleshooting system memory
- Troubleshooting an optical drive
- Troubleshooting a drive
- Troubleshooting expansion cards
- Troubleshooting processors
- Getting help
Dell PowerEdge T30 Owner's Manual
Installing the system fan
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
CAUTION: Do not operate the system with the cover removed for a duration exceeding 5 minutes.
CAUTION: Do not remove or install the system fan by holding the fan blades.
- Follow the safety guidelines listed in the Safety instructions section.
- Follow the procedure listed in the Before working inside your system section.
Steps
- Hold the system fan by the sides with the cable end facing the bottom of the chassis.
- Align the four grommets of the system fan with the four grooves on the sides of the system fan.
- Pass the grommets through the corresponding grooves on the system fan.
- Stretch the grommets and push the system
fan towards the chassis till it locks into place.
NOTE: Install the two lower grommets first.
Figure 1. Installing the system fan 
Next steps
- Connect the system fan power cable to the system fan connector on the system board.
- Follow the procedure listed in the After working inside your system section.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\