Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge T30 Owner's Manual

Installing a 3.5-inch hard drive carrier in the hard drive bay

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. If applicable, disconnect the SATA cables.

Steps

  1. Align the guide ridges of the hard drive carrier with the grooves on the hard drive bay.
  2. Insert and push the hard drive into the hard drive bay until it clicks into place.
    Figure 1. Installing a 3.5-inch hard drive carrier in the hard drive bay
    The figure shows installing a 3.5-inch hard drive in the hard-drive bay.

    NOTE: For information on cabling the hard drives, see the System Information Label on the system cover.

    NOTE: Ensure that SATA cables with a right angle connector are used to connect the hard drives in the hard drive bay.

Next steps

  1. If applicable, connect the power and data cables to the hard drive(s).
  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\