Introduction to Storage Center Initial Configuration
The Storage Center Initial Configuration page provides a list of prerequisite actions that must be performed and information that is required
to initialize a Storage Center.
Prerequisites
The host server, on which the Storage Manager software
is installed, must be on the same subnet or VLAN as the Storage Center.
Layer 2 multicast must be allowed on the network.
Make sure that IGMP snooping is disabled on the switch
ports connected to the Storage Center.
Steps
Make sure the prerequisites that are listed on the Storage Center Initial Configuration page are met.
Make sure the information that is required to initialize the Storage Center is gathered.
Click Next. The Select a to Initialize page is displayed and it lists
the uninitialized Storage Centers discovered by the wizard.
NOTE: If the wizard does not discover the Storage Center that you want to initialize, perform the
following actions:
Make sure that the Storage Center hardware is physically attached to all necessary networks.
Temporarily disable any firewall on the host server
that is running the Storage Manager software.
Click Rediscover to rediscover the uninitialized Storage Centers.
Follow the steps in Deploy the Storage Center Using the Direct Connect
Method.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\