Dell PowerEdge VRTX Enclosure Owner's Manual

Configuration wizard

1. If the enclosure is off, press the enclosure power button to turn it on.
   The LCD screen displays a series of initialization screens as it turns on. When it is ready, the Language Setup screen is displayed.
2. Select a language from the options in the dialog box.
   The following message is displayed on the enclosure screen: Configure Enclosure?
3. Press the center button to continue to the CMC Network Settings screen.
4. Configure the CMC network settings for your network environment:
   • Network speed
   • Duplex mode
   • Network mode (DHCP or static)
   • Static IP address, subnet mask, and gateway values (if static mode was selected)
   • DNS settings
5. If required, configure the iDRAC network settings.

   For more information about iDRAC, see the iDRAC User’s Guide at Dell.com/support/manuals.

   NOTE: The configuration wizard automatically configures each server module’s iDRAC internal network interface if you do not choose to manually configure the iDRAC settings.

   NOTE: You cannot set a static IP address for the iDRAC using the LCD configuration wizard. To set a static IP address, use the CMC web-based interface or Remote Access Controller Administrator (RACADM).
6. Review the settings on the Network Summary screen:
   • If the settings are correct, press the center button to close the configuration wizard and return to the Main Menu.
   • If the settings are not correct, use the left arrow key to return to the screen for that setting and correct it.