Dell PowerEdge VRTX Enclosure Owner's Manual

Removing the optional wheel assembly

1. Remove any cables routed through the power cable retention bracket.
2. Slide the power cable retention bracket to the right to unlock it.
3. Holding it by the edges, pull the bracket out of the chassis slots and away from the chassis.
4. To reduce the chassis weight, remove the following (if required):
   1. Front bezel (if installed)
   2. Hard drives. See Removing A Hot-Swap Hard Drive.
   3. Server modules. See Removing A Server Module.
   4. Power supply units (PSUs). See Removing A Power Supply.
5. Lay the enclosure on a sturdy, stable surface with the cover release latch side on top, and the base of the enclosure extending slightly off the surface edge.
6. Loosen the two screws securing the front and back wheel plates to the chassis.
7. Remove the metal stands on the front and back wheel plates from the hooks on the system base cover.
8. Remove the front and back wheel plates away from the chassis base.
9. Place the enclosure upright on a sturdy, stable surface and rotate the system feet outward.