Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell Edge Gateway 3001 Installation and Operation Manual

PDF

Login to the Edge Gateway using Ethernet Port 1

These are the factory default settings:

  • Username: admin
  • Password: admin
  • Network interface: eth0
  • IPv4 method: auto
  1. Access the dhcp server or setup the dhcp service as described in Installing or configuring Dynamic Host Configuration Protocol (DHCP) daemon.
  2. Find the IP address assigned to the client Edge Gateway.
    NOTE: The MAC ID is printed on the label of the Edge Gateway.
    NOTE: The machine name is pre-configured and is the same as the Service Tag of the Edge Gateway.
  3. Remote login via ssh session. For example:
    # ssh admin@10.101.46.209
    NOTE: 10.101.46.209 is an example, and should be replaced with the IP address obtained in step 2.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\