Dell Edge Gateway 3001 Installation and Operation Manual

Boot up and login—Static IP system configuration

NOTE: To help set up the Edge Gateway remotely, the static IP address of Ethernet port two on the Edge Gateway is set to these values at the factory:

You can connect your Edge Gateway to a Windows computer that is on the same subnet using a crossover cable.

On the Windows computer, search for View network connections in the control panel.
In the list of network devices displayed, right-click the Ethernet adaptor that you want to use to connect to the Edge Gateway, then click Properties.
On the Networking tab, click Internet Protocol Version 4 (TCP/IPv4) > Properties.
Select Use the following IP address, then enter 192.168.2.x (where x represents the last digit of the IP address, for example, 192.168.2.2).
NOTE: Do not set the IPv4 address to the same IP address as the Edge Gateway. Use an IP address between 192.168.2.2 to 192.168.2.254.
Enter the subnet mask 255.255.255.0 , then click OK.
Secure a crossover network cable between Ethernet port two on the Edge Gateway and the configured Ethernet port on the computer.
On the Windows computer, launch Remote Desktop Connection.
Connect to the Edge Gateway using the IP address 192.168.2.1. The default username and password are both admin.