- About This Guide
- Notes, Cautions, and Warnings
- Introduction
- Deployment Prerequisites
- Install and Connect the FS8600 Hardware
- Configure the
FluidFS Cluster
- Configure FluidFS Cluster Network Settings
- Connect to the FluidFS Cluster CLI
- Configure Cluster IP Addresses and the Default Gateway
- Use Dell Storage
Manager to Configure the FluidFS Cluster
- Prerequisites
- Log In to Dell Storage Manager
- Add the FluidFS Cluster to Dell Storage Manager
- Select Appliances
- Configure the Client Network
- Configure the Default Gateway
- Configure DNS Settings
- Configure Time Settings
- Select Storage Centers
- Configure Fibre Channel SAN Connectivity
- Configure iSCSI SAN Connectivity
- Finalize FluidFS Cluster Configuration
- Remove a FluidFS Cluster From Dell Storage Manager
- Configure FluidFS Cluster Network Settings
- Perform Post-Setup Tasks
- Upgrade an Appliance to the Latest FluidFS 6.0 Version
- iSCSI Switch Configuration Examples
Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide
Next Steps
After deployment is complete, perform additional tasks to configure the FluidFS cluster for the network environment. These tasks depend on the configuration, so some might not apply to your site.
See the Dell Storage Manager Administrator’s Guide for detailed configuration instructions, including how to:
- Configure Active Directory and NIS/LDAP (if skipped in the Add FluidFS Cluster wizard)
- Configure multitenancy (disabled by default, enable if desired)
- Create NAS volumes
- Create network shares
- Create quota rules
- Configure antivirus scanning
- Create snapshot schedules
- Configure NDMP backups
- Configure replication to a remote FluidFS cluster
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"