Dell PowerEdge FN I/O Module Configuration Guide 9.10(0.0)

To configure switch mode to Fabric services, use the following commands.

1. Configure Switch mode to FCF Port. CONFIGURATION mode feature fc fport domain id 2
   • NOTE: Enable remote-fault-signaling rx off command in FCF FPort mode on interfaces connected to the Compellent and MDF storage devices.
2. Create an FCoE map with the parameters used in the communication between servers and a SAN fabric. CONFIGURATION mode fcoe-map map-name
3. Configure the association between the dedicated VLAN used to carry FCoE traffic between servers and a SAN, and the fabric where the desired storage arrays are installed. FCOE MAP mode fabric-id fabric-num vlan vlan-id
4. Configure the FCoE mapped address prefix (FC-MAP) value which is used to identify FCoE traffic transmitted on the FCoE VLAN for the specified fabric. FCOE MAP mode fc-map fc-map-value
5. Configure the SAN fabric to which the FC port connects by entering the name of the FCoE map applied to the interface. INTERFACE mode fcoe-map <fcoe-map-name> tengigabitEthernet slot/port The FCoE map contains FCoE and FC parameter settings (refer to FCoE Maps). Manually apply the fcoe-map to any Ethernet ports used for FCoE.