Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge T320 Systems Owner's Manual

PDF

Removing The Optical Drive Or Tape Drive

  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. If installed, remove the front bezel.
  2. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
    • NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
  3. Open the system.
  4. Disconnect the power and data cable from the back of the drive. Note the routing of the power and data cable inside the chassis as you remove them from the system board and the drive. You must route these cables properly when you replace them to prevent them from being pinched or crimped.
  5. To remove the drive, push the release latch towards the bottom of the system.
  6. Slide the drive out of the system until it is free of the drive bay.
    • NOTE: If the drive is being permanently removed, install a blank in the slot.
    • NOTE: Filler brackets must be installed over empty optical drive or tape drive slots to maintain FCC certification of the system. The brackets also keep dust and dirt out of the system and aid in proper cooling and airflow inside the system.
  7. Close the system.
  8. If applicable, install the front bezel.
  9. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
  10. Reconnect the system to its electrical outlet and turn the system on, including any attached peripherals.
    Figure 1. Removing and Installing the Optical Drive or Tape Drive The figure shows removing and installing the optical drive or tape drive.
    1. optical drive
    2. tape drive
    3. release latch
    Figure 2. Cabling—Optical Drive and Tape Drive The figure shows cabling the optical drive and tape drive.
    1. connector for power cable extension
    2. mini-SAS connector on PERC card
    3. ODD2/TBU connector on system board
    4. ODD1/TBU connector on system board
    5. power connector on x8 backplane
    6. SAS tape drive data/power connector
    7. optical drive2 power connector
    8. optical drive2 data connector
    9. optical drive1 power connector
    10. optical drive1 data connector

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"