Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge T320 Systems Owner's Manual

PDF

Replacing The System Battery

  • WARNING: There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or equivalent type recommended by the manufacturer. See your safety information for additional information.
  • CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
  2. If applicable, rotate the system feet inward and lay the system on its side on a flat, stable surface.
    • NOTE: For systems installed with the wheel assembly, ensure that you lay the system on a sturdy, stable surface with the wheel assembly extending off the edge of the surface.
  3. Open the system.
  4. Locate the battery socket.
    • CAUTION: To avoid damage to the battery connector, you must firmly support the connector while installing or removing a battery.
  5. To remove the battery, support the battery connector by pressing down firmly on the positive side of the connector.
    Figure 1. Removing and Installing the System Battery The figure shows removing and installing the system battery.
    1. positive side of battery connector
    2. system battery
  6. Lift the battery out of the securing tabs at the negative side of the connector.
  7. To install a new system battery, support the battery connector by pressing down firmly on the positive side of the connector.
  8. Hold the battery with the "+" facing up and slide it under the securing tabs at the positive side of the connector.
  9. Press the battery straight down into the connector until it snaps into place.
  10. Install the cooling shroud.
  11. Close the system.
  12. If applicable, place the system upright on a flat, stable surface and turn the system feet outward.
  13. Reconnect the system to the electrical outlet and turn the system on, including any attached peripherals.
  14. Enter the System Setup to confirm that the battery is operating properly.
  15. Enter the correct time and date in the System Setup Time and Date fields.
  16. Exit the System Setup.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"