Dell Chassis Management Controller Version 2.10 for PowerEdge FX2 and FX2s RACADM CLI Guide

testemail

Table 1. Details of testemail. The following table provides the details of testemail attribute:
Description	Sends a test e-mail from CMC to a specified destination. Prior to executing the test e-mail command, make sure that the SMTP server is configured and the specified index in the RACADM cfgEmailAlert group is enabled and configured properly.
Synopsis	racadm testemail -i < index>
Input	-i — Specifies the index of the e-mail alert to test.
Output	Success: Test e-mail sent successfully Failure: Unable to send test e-mail
Example	Commands for the cfgEmailAlert group: Enable the alert — racadm config -g cfgEmailAlert -o cfgEmailAlertEnable -i 1 Set the destination e-mail address — racadm config -g cfgEmailAlert -o cfgEmailAlertAddress -i 1 user1@mycompany.com Set the custom message that is sent to the destination e-mail address — racadm config -g cfgEmailAlert -o cfgEmailAlertCustomMsg -i 1 "This is a test!" Make sure that the SMTP IP address is configured properly — racadm config -g cfgRemoteHosts -o cfgRhostsSmtpServerIpAddr 192.168.0.152 View the current e-mail alert settings — racadm getconfig -g cfgEmailAlert -i < index> where < index> is a number from 1 to 4.