Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R330 Owner's Manual

PDF

Installing the optional 1.8-inch solid state drives

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Ensure that you follow the Safety instructions.
  2. Follow the procedure listed in Before working inside your system.
  3. If installed, remove the optical drive blank or the solid state drives (SSDs) tray by pressing the blue release tab at the back of the blank or tray and pushing the blank or tray out of the system.

Steps

  1. Align and insert the SSD into the SSD tray.
  2. Press the SSD until it locks into place.
    Figure 1. Installing the 1.8-inch solid state drives into the SSD tray
    This figure shows installing the 1.8-inch solid state drives into the SSD tray.
    1. SSD tray
    2. tabs on the tray
    3. SSD
    4. SSD release tab
  3. Press the SSD release tab on the SSD tray, and slide the SSD under the tabs on the tray.
  4. Press the SSD until it locks into place.
  5. Align the SSD tray with the optical drive slot on the front of chassis.
  6. Slide the SSD tray into the slot until the latch snaps into place.
  7. Connect the power and data cable to the back of the SSD.
  8. Route the power and data cable underneath the cable routing latch of the system.
  9. Connect the power and data cable to the connectors on the system board.
    Figure 2. Installing the 1.8-inch SSD tray
    This figure shows installing the 1.8-inch SSD tray.
    1. SSD tray
    2. SSD
    3. data and power cable
    4. tray release tab

Next steps

Follow the procedure listed in After working inside your system.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"