- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the battery-status light cable with microphones
- Replacing the battery-status light cable with microphones
- Removing the touchpad
- Replacing the touchpad
- Removing the I/O-board cable
- Replacing the I/O-board cable
- Removing the I/O board
- Replacing the I/O board
- Removing the display assembly
- Replacing the display assembly
- Removing the display hinge cover
- Replacing the display hinge cover
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the fan
- Replacing the fan
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 Service Manual
Flea power release
Flea power
is the residual static electricity that remains on the computer even
after it has been powered off and the battery has been removed. The
following procedure provides the instructions on how to conduct flea
power release:
- Turn off your computer.
- Remove the base cover.
- Follow step 1 in " Removing the battery".
- Press and hold the power button for 15 seconds to drain the flea power.
- Follow step 4 in " Replacing the battery".
- Replace the base cover.
- Turn on your computer.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"