- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the battery-status light cable with microphones
- Replacing the battery-status light cable with microphones
- Removing the touchpad
- Replacing the touchpad
- Removing the I/O-board cable
- Replacing the I/O-board cable
- Removing the I/O board
- Replacing the I/O board
- Removing the display assembly
- Replacing the display assembly
- Removing the display hinge cover
- Replacing the display hinge cover
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the fan
- Replacing the fan
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 Service Manual
Procedure
- Align the screw holes on the touchpad with the screw holes on the palm-rest assembly.
- Replace the four screws (M2x2) that secure the touchpad to the palm-rest assembly.
- Slide the touchpad cable into the connector on the system board and close the latch to secure the cable.
- Route the touchpad cable and adhere the cable to the keyboard and palm-rest assembly.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"