- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the battery-status light cable with microphones
- Replacing the battery-status light cable with microphones
- Removing the touchpad
- Replacing the touchpad
- Removing the I/O-board cable
- Replacing the I/O-board cable
- Removing the I/O board
- Replacing the I/O board
- Removing the display assembly
- Replacing the display assembly
- Removing the display hinge cover
- Replacing the display hinge cover
- Removing the antenna
- Replacing the antenna
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the fan
- Replacing the fan
- Removing the keyboard
- Replacing the keyboard
- Removing the palm-rest assembly
- Replacing the palm-rest assembly
- Downloading drivers
- System setup
- Troubleshooting
- Getting help and contacting Dell
XPS 13 Service Manual
Procedure
- Slide the palm-rest assembly under the display hinges and align the screw holes on the palm-rest assembly with the screw holes on the display hinges.
- Replace the four screws (M2.5x4) that secure the palm-rest assembly to the display hinges.
- Close the palm-rest assembly.
- Connect the display cable to the system board.
- Align the screw holes on the display-cable bracket with the screw holes on the system board.
- Replace the two screws (M2x3) that secure the display-cable bracket to system board.
- Adhere the tape over the display-cable bracket.
- Route the display cable through the routing guides on the fan.
- Connect the media-card reader cable to the I/O board.
- Adhere the tape that secures the display cable to the fan and the I/O board.
- Replace the screw (M1.6x3) that secures the display cable to the I/O board.
- Connect the antenna cables to the wireless card.
- Align the screw hole on the wireless-card bracket with the screw hole on the system board.
- Replace the screw (M2x3) that secures the wireless-card bracket to the system board.
- Adhere the tape that secures the antenna cables to the system board.
- Connect the touchscreen cable (optional) and camera cable to the system board.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"