Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Connecting to PCoIP Remote Access Host Cards in Dell Precision Host Workstations Quick Reference Guide

PDF

Configuring the Wyse or Amulet DXZ4 PCoIP Zero Client

To configure the Wyse or Amulet DXZ4 PCoIP Zero Client:
NOTE: You will need the MAC address, IP address, and Subnet Mask address of the host card when you configure the Wyse or Amulet DXZ4 PCoIP Zero Client.
  1. Connect the AC adapter to the Wyse or Amulet DXZ4 PCoIP Zero Client and turn it on.
  2. On the management computer, launch the Web browser and type 192.168.1.50 .
  3. Click the Continue to the website (not recommended) option by disregarding the message.
  4. The Log In screen appears.
  5. The default password for Wyse Zero clients is Administrator. The default password for the Amulet DXZ4 Zero Client it is ahkdante
  6. Skip the Idle Timeout field, and click Log In.
  7. The Home screen appears.
  8. Select the Network tab and then Session .Select Direct to host +SLP Host Discovery and click Apply .
  9. Select the Configuration tab and then the Initial setup tab:
    1. Uncheck Enable DHCP.
    2. Change the default IP address to an IP address of your choice.
    3. Change the default Subnet Mask address to your target Subnet Mask address.
    4. Leave the Primary DNS Server and Secondary DNS Server fields populated with zeros.
    5. Click Apply
  10. On the Success screen, click Reset.
  11. Click OK once you see the confirmation message.
  12. On the Your Session Has Ended message, click OK. The Log In screen appears.
  13. Close your web browser.
  14. The Wyse or Amulet DXZ4 PCoIP Zero Client is now configured and ready for use.
NOTE:
  1. Although the Quad Display PCoIP Zero Client could be connected over the LAN to a dual display remote access host card (used with the 5030 dual display PCoIP Zero Client), there is no notable benefit, since the dual display remote access card is limited to supporting two displays at 1920 X 1220 or one display at 2560 X 1600). Also, connecting two remote access host cards to a Quad display PCoIP Zero Client is not possible since the Quad display PCoIP Zero Client has a single NIC with one IP address. Each host card has a NIC with separate IP addresses.
  2. Although possible but it is not recommended to connect the Zero clients directly to workstation host cards, it should be done through a switch or router.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\