Dell Chassis Management Controller Version 2.10 for PowerEdge FX2 and FX2s User's Guide

Deactivating FlexAddress

The FlexAddress feature can be deactivated and the SD card returned to a pre-installation state by using a RACADM command. There is no deactivation function within the Web interface. Deactivation returns the SD card to its original state where it can be installed and activated in another chassis. The term FlexAddress, in this context, implies both FlexAddress and FlexAddressPlus.

NOTE: The SD card must be physically installed in CMC, and the chassis must be turned off before running the deactivation command.

If you run the deactivation command without installing an SD card, or with a card from a different chassis installed, the feature is deactivated and change is not made to the card.

To deactivate the FlexAddress feature and restore the SD card:

racadm feature -d -c flexaddress

The command returns the following status message if it is successfully deactivated:

feature FlexAddress is deactivated on the chassis successfully.

If the chassis is not turned off before running the command, the command throws the following error:

ERROR: Unable to deactivate the feature because the chassis is powered ON

NOTE: To activate the FlexAddress feature again, re-boot the CMC.

For further information about the command, see the feature command section of the Dell Chassis Management Controller for PowerEdge FX2/FX2s RACADM Command Line Reference Guide.

Kedves

Üdvözli a Dell!

Dell Chassis Management Controller Version 2.10 for PowerEdge FX2 and FX2s User's Guide

Deactivating FlexAddress

Rate this content