Passa al contenuto principale
Esci

Benvenuto in Dell

Il mio account
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.
Accedi Crea un account Accesso a Premier Accesso al Partner Program
Contattaci

I tuoi carrelli Dell.com

Dell PowerEdge T630 Owner's Manual

PDF

Installing a heat sink

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. If installed, remove the cooling fan assembly.
  4. If installed, remove the full-length PCIe card.
  5. Install the processor.
  6. Keep the Phillips #2 screwdriver ready.

Steps

  1. If you are using an existing heat sink, remove the thermal grease from the heat sink by using a clean lint-free cloth.
  2. Use the thermal grease syringe included with your processor kit to apply the grease in a thin spiral on the top of the processor.
    CAUTION: Applying too much thermal grease can result in excess grease coming in contact with and contaminating the processor socket.
    NOTE: The thermal grease syringe is intended for one-time use only. Dispose of the syringe after you use it.
    Figure 1. Applying thermal grease on the top of the processor
    This figure shows applying thermal grease on the top of the processor.
    1. processor
    2. thermal grease
    3. thermal grease syringe
  3. Place the heat sink onto the processor.
  4. Tighten one of the four screws to secure the heat sink to the system board.
  5. Repeat the procedure for the remaining two screws.
    Figure 2. Installing the heat sink
    This figure shows installing the heat sink.

    1. heat sink

    2. retention screw (4)

    3. retention screw slot (4)

    4. processor socket

Next steps

  1. If applicable, install the PCIe card.
  2. If applicable, install the cooling fan assembly.
  3. Follow the procedure listed in the After working inside your system section.
  4. While booting, press F2 to enter System Setup and verify that the processor information matches the new system configuration.
  5. Run the system diagnostics to verify that the new processor operates correctly.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \