Dell FluidFS Version 6.0 FS8600 Appliance Deployment Guide

Use the Connectivity Report page to verify iSCSI connectivity between the FluidFS cluster and the Storage Centers.

1. Use the report to verify iSCSI connectivity.
   • When the Connectivity Report initially opens, iSCSI logins might still be occurring in the background, causing some or all of the FluidFS cluster iSCSI initiators to show the status as Not Found/Disconnected. If this status is displayed, wait 30 seconds, then click Refresh to update the report.
     Figure 1. Add FluidFS Cluster Wizard — Connectivity Report (Not Found/Disconnected)
   • When the iSCSI logins are complete and the report has been refreshed, the status for each FluidFS cluster initiator shows as Up.
     Figure 2. Add FluidFS Cluster Wizard — Connectivity Report (Up)
2. If the iSCSI configuration is correct, proceed to step 3. Otherwise, perform the following steps to modify the iSCSI configuration. After you are past the Connectivity Report page, you will no longer be able to modify the iSCSI configuration using the Add FluidFS Cluster wizard.
   1. Close the Add FluidFS Cluster wizard by clicking the Close ( x) button in the top-right corner of the wizard. The Summary tab is displayed.
      Figure 3. Cluster Setup Not Complete
   2. Click Next. The Existing iSCSI Configuration page opens.
      Figure 4. Add FluidFS Cluster Wizard — Existing iSCSI Configuration Page
   3. Select Remove existing iSCSI Configuration .
   4. Click Next. The Select Storage Centers page opens. See Select Storage Centers .
3. Click Next. The Configure NAS Pool page opens.