Treceți la conținutul principal
Deconectare

Bun venit la Dell

Contul meu
  • Plasaţi comenzi rapid şi simplu
  • Vizualizaţi comenzile şi urmăriţi starea transportului
  • Creaţi şi accesaţi o listă cu produsele dvs.
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Autentificare Creaţi un cont Autentificare la Premier Autentificare la programul pentru parteneri
Contactaţi-ne

Dell Wyse ThinLinux 1.0.3 Administrator’s Guide

PDF

Configuring and managing the SSH connections

The SSH connections page enables you to create and manage the SSH connections. The main SSH connections page has options to create an SSH connection.
To configure the SSH connection, complete the following task:
  1. Click the + icon to add a new SSH Connection. The SSH Connections page is displayed.
    Figure 1. SSH Connections Settings
  2. Enter the name of the SSH connection.
    Figure 2. SSH Connections Settings
  3. Enter the IP address or FQDN of the SSH server that you want to connect to.
  4. Enter the Username to log in to the remote SSH Server.
  5. Enter the command to run the program.
  6. Click the ON/OFF button to enable or disable the Auto-connect after login option. If enabled, the connection is automatically connected after you log in to your thin client.
  7. Click the ON/OFF button to enable or disable the Auto-reconnect after disconnected option. If enabled, the connection is automatically re-connected after you disconnect from the session.
  8. Select the amount of time in seconds to delay the reconnection attempt after a disconnection occurs.
  9. Click Save to save the changes.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\