Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Enabling Serial Connection IPMI Serial Settings Using RACADM

To configure IPMI Serial settings, you use the set or config command:
  1. Change the IPMI serial connection mode to the appropriate setting using the command:
    • Using config command: racadm config -g cfgSerial -o cfgSerialConsoleEnable 0
    • Using set command: racadm set iDRAC.Serial.Enable 0
  2. Set the IPMI Serial baud rate:
    • Using config command: racadm config -g cfgIpmiSerial -o cfgIpmiSerialBaudRate <baud_rate>
    • Using set command: racadm set iDRAC.IPMISerial.BaudRate <baud_rate>
    where <baud_rate> is 9600, 19200, 57600, or 115200 bps.
  3. Enable the IPMI serial hardware flow control:
    • Using config command: racadm config -g cfgIpmiSerial -o cfgIpmiSerialFlowControl 1
    • Using set command: racadm set iDRAC.IPMISerial.FlowControl 1
  4. Set the IPMI serial channel minimum privilege level:
    • Using config command: racadm config -g cfgIpmiSerial -o cfgIpmiSerialChanPrivLimit <level>
    • Using set command: racadm set iDRAC.IPMISerial.ChanPrivLimit <level>
    where <level> is 2 (User), 3 (Operator), or 4 (Administrator).
  5. Make sure that the serial MUX (external serial connector) is set correctly to the remote access device in the BIOS Setup program to configure BIOS for serial connection. For more information about these properties, see the IPMI 2.0 specification.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\