Ana içeriğe atla
Oturumu Kapat

Dell'e Hoş Geldiniz

Hesabım
  • Hızla ve kolayca sipariş verin
  • Siparişleri görüntüleyin ve kargonuzun durumunu izleyin
  • Ürünlerinizin listesini oluşturun ve listeye erişin
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Oturum Aç Hesap oluşturun Premier Oturum Açma İş Ortağı Programı Oturum Açma
Bize Ulaşın

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

PDF

Updating Single Device Firmware

Before updating the firmware using single device update method, make sure that you have downloaded the firmware image to a location on the local system.

To update single device firmware using iDRAC7 Web interface:

  1. Go to Overview > iDRAC Settings > Update and Rollback . The Firmware Update page is displayed.
  2. On the Update tab, select Local as the File Location.
  3. Click Browse, select the firmware image file for the required component, and then click Upload.
  4. After the upload is complete, the Update Details section displays each firmware file uploaded to iDRAC and its status. If the firmware image file is valid and was successfully uploaded, the Contents column displays a icon next to the firmware image file name. Expand the name to view the Device Name, Current, and Available firmware version information.
  5. Select the required firmware file to be updated and do one of the following:
    • For firmware images that do not require a host system reboot, click Install. For example, iDRAC firmware file.
    • For firmware images that require a host system reboot, click Install and Reboot or Install Next Reboot.
    • To cancel the firmware update, click Cancel.
    • NOTE: If you have uploaded the same firmware image file more than once, only the latest firmware file is available for selection. The check box for the earlier firmware image files is disabled.

    When you click Install, Install and Reboot or Install Next Reboot, the message Updating Job Queue is displayed.

  6. Click Job Queue to display the Job Queue page, where you can view and manage the staged firmware updates or click OK to refresh the current page and view the status of the firmware update.
    • NOTE: If you navigate away from the page without committing the updates, an error message is displayed and all the uploaded content is lost.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\