You can set
alerts and actions for certain events that occur on the managed system.
An event occurs when the status of a system component is greater than
the pre-defined condition. If an event matches an event filter and
you have configured this filter to generate an alert (e-mail, SNMP
trap, IPMI alert, remote system logs, Redfish event, or WS events),
then an alert is sent to one or more configured destinations. If the
same event filter is also configured to perform an action (such as
reboot, power cycle, or power off the system), the action is performed.
You can set only one action for each event.
iDRAC to send alerts:
Optionally, you can filter the alerts based
on category or severity.
Configure the e-mail alert, IPMI alert, SNMP
trap, remote system log, Redfish event, operating system log, and/or
Enable event alerts and actions such as:
Send an email alert, IPMI alert, SNMP traps, remote
system logs, Redfish event, operating system log, or WS events to
Perform a reboot, power off, or power cycle the managed