- Notes, cautions, and warnings
- Introduction
- Advantages of using Lifecycle Controller
- Benefits of using iDRAC with Lifecycle Controller
- Key features
- New in this release
- Advantages of using Lifecycle Controller Remote Services
- Licensable features in Lifecycle Controller
- About iDRAC RESTful API with Redfish and Web Service APIs
- About Lifecycle Controller API
- About one-to-many management achieved
- Other information that you may need
- Accessing documents from the Dell EMC support site
- Contacting Dell
- Remote Services Features
- Deployment and configuration
- Monitor
- Maintain
- Job management
- Getting started with API collateral and links
- Integrating the Lifecycle Controller API
- Social media reference
- Terms and definitions
Dell Lifecycle Controller Remote Services v2.60.60.60 Quick Start Guide
NIC configuration
Network Interface Controller (NIC) configuration feature is used to set up or modify configuration settings for supported NIC cards (for example, Intel, QLogic, and Broadcom). These configuration settings can be set or updated both locally and remotely using Lifecycle Controller-Remote Services.
The NICs supported by Lifecycle Controller provide an array of
networking features converged into a single controller:
- Traditional NIC capabilities
- Internet Small Computer System Interface over Ethernet (iSCSI) capabilities
- Fibre Channel over Ethernet (FCoE) capabilities
You can configure various device capabilities such as:
- Personalities (FCoE, ISOE, Layer 2 NIC)
- NIC partition bandwidth allocation
- Boot versus Offload
- I/O Identity
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
請給予評分 (1 到 5 顆星)。
本文章是否有幫助？請選擇。
評語中不得包含下列特殊字元：<>()\