OEMR R6515

了解如何在戴尔设备上使用 iDRAC9 和 iDRAC10 创建和导出 SupportAssist 收集。使用此分步指南解决技术问题。

本文介绍了 PowerEdge 服务器中风扇噪音的一些常见的可能原因以及故障处理方法。 它还与 100% 风扇速度有关。

在 iDRAC 重新启动后不久尝试更新时，BIOS/CPLD 或背板固件 DUP 可能无法更新。

对于戴尔和 FCoE 初始化协议 （FIP） 驱动器，960 GB 和 800 GB 版本的驱动器之间共享制造商部件编号。

This article explains a scenario when a Samsung PM883a SSDs with HG57 or earlier firmware versions may report ERRORMOD and report 0GB size under rare situations.

This article shows How To determine why a virtual machine powered off or rebooted by reviewing log files and host details to identify guest shutdowns, user or API requests, HA resets or system faults.

Dell iDRAC9 and iDRAC10 remediations for a Command Injection security vulnerability that could be exploited by malicious users to compromise the affected system.

To replace a CMOS battery, remove the air shroud, disconnect and remove any expansion cards, locate the battery socket, and carefully pry out the CMOS battery. After installing a new CMOS battery, you must reinstall the expansion cards, install the air shroud, and restore the BIOS settings, ensuring the battery is operating properly and the correct data and time are set in the System Setup.

This article describes how to find the iDRAC's current MAC address.

Frequently Asked Questions (FAQ) about Physical Drives replacement in RAID Server and MD Arrays

This article provides steps to troubleshoot a chassis intrusion, chassis open message for PowerEdge servers.

This article provides information about how to delete a virtual disk using the Device Settings menu on a PowerEdge server. If your PowerEdge server is running the UEFI mode as a boot mode, the RAID BIOS is not displayed.

This article provides information about how to disable C-States and C1E on a PowerEdge Server.

The article describes updating Dell PowerEdge server firmware through Integrated Dell Remote Access Controller (iDRAC) 7, 8, 9, or 10. It details downloading the firmware image, logging in to the iDRAC web interface, uploading the image for installation, and managing pending updates.

This article provides information about identifying the hard driver properties in OMSA, system setup page, and iDRAC interface.

This article explains how to restore the BIOS defaults settings on a Dell PowerEdge Server. This procedure may be valid for other Dell products.

Explore various RAID levels - RAID 0, 1, 5, 6, and 10 - implemented in Dell PowerEdge servers. Learn about their configurations, benefits, and how they impact data redundancy and performance.

Dell SS540 SAS 固态硬盘报告为无法正常工作。

SR-IOV - 升级到 BIOS 版本 2.14.1 后，网络接口控制器 （NIC） 虚拟功能 （VF） 可能会失败。

在某些迁移场景中，OpenManage Enterprise 4.0 目标导入操作可能会在迁移过程中失败，并显示错误“无法解密备份归档”。使用以下文章帮助对此情形进行故障处理以及解决故障的各种方法。

戴尔英特尔 E810-C 适配器不支持使用“Intnetcli”工具禁用虚拟机设备队列 （VMDQ） 环回功能。

戴尔 Samsung 串行连接 SCSI （SAS） PM1653 和 PM1655 固态硬盘可能会报告过多的感知键故障 0x3、0x11、0x0 或 0x4、0x29、0x4。这些故障可能会导致意外的驱动器问题。

以下文章是一种解决方法，PowerEdge用于从一些版本的 iDRAC 的关键日志条目“SWC5008 由于硬件错误情况，无法访问前 LED 面板”恢复系统。

客户报告 Toshiba MG08（24HF9、4N7V0、8MG73）驱动器的故障率高于预期。

在 ESXi 主机上配置 PCI 设备直通并将设备添加到虚拟机后，虚拟机无法开启。它卡在 80% 处，然后导致错误“所需的总页数 （4206594） 超出限制 （917504）”。

This page explains the difference between drivers and firmware and how to update them on Dell PowerEdge Servers using different methods.

Dell Enterprise SAS, SATA SSD: SMART predictive failures triggered by remaining write endurance falling below the threshold

Micron 5x00 Series SSDs may experience read/write performance degradation after reaching approximately 65,535 power-on hours (POH), which equates to roughly 7.5 years of operation. This issue affects performance only and does not result in data loss or drive failure.

在开机自检时看到“AMD EPYC 处理器未融合到戴尔平台”消息。

这是一个固件目录，其中包含某些戴尔的 VMware vSAN Ready Node 的经过验证和认证的固件堆栈。