Removal
Base Cover
Identify the base cover highlighted in blue
Remove the screws that secure the base cover to the system base.
Loosen the captive screw that secures the base cover to the system base.
Using a plastic scribe or a flat head screwdriver, gently pry clips on the base cover to release them from the slots on the system base.Lift the base cover off the system base
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity
Memory Modules
Identify the memory module highlighted in blue
Using your fingertips, carefully spread apart the securing clips on each end until the memory module pops up.
Hold the edges and lift the memory module up from connector on the system board
Install
Memory Modules
Identify the memory module location highlighted in blue
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable highlighted in blue
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Slide the tabs on the base cover into the slots on the system base and snap the base cover into place.
Tighten the captive screw that secures the base cover to the system base.
Install the screws that secure the base cover to the system base.