Removal
Side Cover
Identify the side cover highlighted in blue.
Using a phillips screwdriver to turn the side panel latch to the unlocked position.
Pull the release latch to release the side cover from the system.
Push the latch and release the side cover from the system.
Lift the side cover away from the system.
Front bezel
Identify the front bezel highlighted in blue.
Gently pry the retention tabs to release the front bezel from the system.
Rotate the front bezel outward from the system and remove the front bezel.
Air Shroud
Identify the air shroud highlighted in blue.
Hold the top air shroud at the grip points and pull it upwards out of the system.
Speaker
Identify the speaker highlighted in blue.
Disconnect the speaker cable from the connector on the system board.
Unroute the speaker cable from the front system.
Unroute the speaker cable from the routing guides on the system.
Press the two tabs and pull the speaker along with the cable from the slot on the system.
Install
Speaker
Identify the speaker location highlighted in blue.
Press the tab on the speaker and slide it into the system slot until it snaps into place.
Route the speaker cable through the routing guide on the system.
Route the speaker cable through the slot on the system.
Connect the speaker cable to the connector on the system board.
Air Shroud
Identify the air shroud location highlighted in blue.
Align the top air shroud over the heat sink and system board.
Install and press the top air shroud down until the tabs click into place.
Front bezel
Identify the front bezel location highlighted in blue.
Align the front bezel tabs with the slots on the system.
Install and rotate the front bezel towards the system, then snap it into place.
Side Cover
Identify the side cover location highlighted in blue.
Align the tabs with the slots and install the side cover on the system.
Use a Phillips screwdriver to turn the side-panel latch to the locked position.