Removal
Base Cover
Identify the base cover highlighted in blue.
Using a Torx #5, remove the screws that secure the base cover.
Starting at the bottom left corner, carefully pry the base cover along the bottom and sides.
Grasp the bottom and rotate it upwards to release the base cover from the system.
Battery Cable
Identify the battery cable highlighted in blue
Use the tab to assist in disconnecting the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
SSD 2280
Identify the solid state drive (SSD) highlighted in blue
Remove the screw that secures the solid state drive to the system board.
Slide and lift the thermal shield to remove it from the system.
Holding the sides of the module, slightly lift and slide the SSD out.
Install
SSD 2280
Identify the solid state drive (SSD) location highlighted in blue
Align the notch on the SSD with the tab on the slot and slide the SSD into the slot.
Slide the solid state drive thermal bracket under the peg on the system board.
Install the screw that secures it to the system board.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Align and install hinge first (careful of the cable inside the cover). Press until it clicks into place.
Install the screws that secure the base cover. (requires Torx #5)