Removal
Base Cover
Align the system with the outline to enable the AR lock.
Loosen the captive screws that secure the base cover to the system
Pry open the base cover from the smart-card reader slot at the bottom right side of the base cover.
Lift the base cover starting from the bottom edge and remove it from the system.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Battery
Identify the battery highlighted in blue.
Remove the screws that secure the battery to the system.
Lift the battery from the system.
Keyboard
Identify the keyboard highlighted in blue.
Turn the system over and open the display.
Identify the keyboard highlighted in blue.
Using a plastic scribe, pry the top edge of the keyboard lattice starting from the recess points and working your way around the sides and bottom edge.
Remove the keyboard lattice from the keyboard.
Remove the screws that secure the keyboard to the system.
Pry the bottom edge of the keyboard and then work along the left and the right sides of the keyboard.
Remove the keyboard with the cable(s) from the system.
Memory (Primary)
Identify the memory module location highlighted in blue
Remove the screw that secures the memory shield in place.
Lift the memory shield to remove it from the system.
Pry the securing clips from both sides of the memory module until the memory module pops up.
Remove the memory module from the memory module slot
Install
Memory (Primary)
Identify the memory module location highlighted in blue.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Install the memory shield above the memory module.
Install the screw to secure the memory shield.
Keyboard
Identify the keyboard location highlighted in blue.
Align the tabs on the keyboard with the tabs on the computer chassis at an angle and place the keyboard on the palmrest.
Install the screws to secure the keyboard to the system.
Install the keyboard lattice and press along the edges and in between keys until it clicks into place.
Close the display and turn the the system over.
Battery
Identify the battery location highlighted in blue.
Insert the battery into the slot on the system.
Install the screws to secure the battery to the system.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide the base cover into its slot until it clicks into place.
Tighten the captive screws to secure the base cover to the system.