Removal
Base Cover
Align the system with the outline to enable the AR lock.
Loosen the captive screws that secure the base cover to the system
Pry open the base cover from the smart-card reader slot at the bottom right side of the base cover.
Lift the base cover starting from the bottom edge and remove it from the system.
Battery Cable
Identify the battery cable highlighted in blue.
Disconnect the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Heat sink assembly
Identify the heat sink assembly highlighted in blue.
Disconnect and peel the power adapter cable from the heat sink assembly.
Disconnect the two fan cables from the connectors on the system board.
Loosen the captive screws that secure the heat sink assembly. Loosen in reverse sequential order.
Lift the heat sink assembly to remove it from the system.
Use the alcohol pad to clean the thermal paste from the system board and heatsink (as shown in the video).
Power adapter port
Identify the power adapter port highlighted in blue.
Remove the screw that secures power adapter cable bracket
Remove the power adapter cable bracket from the system.
Slide the power adapter port towards the rear side of the computer to remove the power-adapter port from its compartment on the computer chassis.
Install
Power adapter port
Identify the power adapter port location highlighted in blue.
Slide the power adapter cable into the slot on the system.
Install the power adapter cable bracket on the power adapter port.
Install the screw to secure the bracket.
Adhere and route the display cable in place.
Heat sink assembly
Identify the heat sink location highlighted in blue.
Apply a pea sized amount of thermal material as shown. Replace thermal pads if needed.
Align and insert the heat sink assembly into its slot on the system.
Tighten the captive screws to secure the heat sink assembly. Tighten in sequential order.
Connect the two fan cables to the connector on the system board.
Adhere the power adapter cable on the heat sink assembly and connect the cable to its connector in system board.
Battery Cable
Identify the battery cable location highlighted in blue.
Connect the battery cable to the connector on the system board.
Base Cover
Identify the base cover location highlighted in blue.
Slide the base cover into its slot until it clicks into place.
Tighten the captive screws to secure the base cover to the system.