Removal
Base Cover
Identify the base cover highlighted in blue.
Using a Torx #5, remove the screws that secure the base cover.
Starting at the bottom left corner, carefully pry the base cover along the bottom and sides.
Grasp the bottom and rotate it upwards to release the base cover from the system.
Battery Cable
Identify the battery cable highlighted in blue
Use the tab to assist in disconnecting the battery cable from the system board.
Press and hold the power button for 10 seconds to ground the system and remove residual static electricity.
Memory Modules
Identify the memory module highlighted in blue.
Peel back the mylar to access the memory module.
Using your fingertips, carefully spread apart the securing clips until the memory module pops up.
Hold the edges and carefully lift the memory module up from connector on the system board.
Install
Memory Modules
Identify the memory module location highlighted in blue.
Peel back the mylar to access the memory module.
Align the notch on the memory module with the tab on the slot and slide the memory into the slot at an angle.
Press the memory module down until it clicks into place.
Battery Cable
Identify the battery cable highlighted in blue.
Connect the battery cable to the system board.
Base Cover
Identify the base cover location highlighted in blue
Align the base cover and press the edges of the cover until it clicks into place.
Install the screws that secure the base cover. (requires Torx #5)