Removal
System Cover
Identify the system cover highlighted in blue.
Rotate the latch release lock counter clockwise to the unlocked position.
Open the latch on the system cover
Slide system cover toward the back and using the latch lift system cover up from system.
Cooling Shroud
Identify the cooling shroud highlighted in blue
Holding the touch points, lift the cooling shroud away from the system.
Riser 1
Identify the expansion card riser 1 highlighted in blue.
Holding the slots on the expansion card riser, lift the riser from the riser connector on the system board
Riser 2
Identify the expansion card riser 2 highlighted in blue
Grip the release tab and lift the riser from the riser connector on the system board
Network Daughter Card (NDC)
Identify the network daughter card (NDC) highlighted in blue
Loosen the captive screws that secure the network daughter card to the system board.
Hold the NDC by the edges on either side of the touch point, and lift the card to disengage it from the connector on the system board.
Slide the NDC away from the back of the system until the ethernet connectors are clear of the slot in the back panel.
Lift the NDC out of the chassis.
Install
Network Daughter Card (NDC)
Identify the network daughter card (NDC) location highlighted in blue
Orient the NDC so that the ethernet connectors fit through the slot in the back panel.
Align the captive screws on the card with the captive screw sockets on the system board.
Press the touch points on the card until the card connector is firmly seated on the system board connector.
Tighten the captive screws to secure the NDC to the system board.
Riser 2
Identify the expansion card riser 2 location highlighted in blue
Lower the riser into the system until the riser connector engages with the connector on the system board
Riser 1
Identify the expansion card riser 1 location highlighted in blue.
Align the guide rails on the riser with the standoffs on the side of the system
Lower the riser into the system until the riser connector engages with the connector on the system board
Cooling Shroud
Identify the cooling shroud location highlighted in blue
Align the tabs on the cooling shroud with securing slots on the system, then lower the cooling shroud into the system until firmly seated.
System Cover
Identify the system cover location highlighted in blue
Align the slots on the system cover with the tabs on the system.
Push the system cover latch down. The system cover slides forward and the slots on the system cover engage with the tabs on the system.
Rotate the latch release lock clockwise to the locked position.