This 3D experience gives you the step by step process of replacing the Wireless Module (WLAN) and a Alienware M16 R2. The procedure will also include removing the Base Cover, Battery Cable and reinstalling them.
<p>Removal</p><p><br></p><p>Base Cover</p><p>Identify the base cover highlighted in blue.</p><p>Loosen the captive screws that secure the base cover to the system.</p><p>Remove the screws that secure the base cover to the system.</p><p>Using a plastic scribe, pry the basecover from bottom left and continue on the sides to loosen.</p><p>Slide and lift the base cover off the system.</p><p><br></p><p>Battery Cable</p><p>Identify the battery cable highlighted in blue.</p><p>Disconnect the battery cable from the system board.</p><p>Press and hold the power button for 20 seconds to ground the system and remove residual static electricity.</p><p><br></p><p>Wireless Module (WLAN)</p><p><br></p><p><br></p><p><br></p><p>Install</p><p><br></p><p>Wireless Module (WLAN)</p><p><br></p><p><br></p><p>Battery Cable</p><p>Identify the battery cable location highlighted in blue.</p><p>Connect the battery cable to the connector on the system board.</p><p><br></p><p>Base Cover</p><p>Identify the base cover location highlighted in blue.</p><p>Slide and align the base cover and press the edges of the cover until it clicks into place.</p><p>Tighten the captive screws that secure the base cover to the system.</p><p>Install the screws that secure the base cover to the system.</p>