Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge FC430 Owner's Manual

PDF

Removing the LOM riser card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that came with the product.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Remove the two screws that secure the LOM riser card to the system board.
  2. Lift the card from the system board.
    Figure 1. Removing the LOM riser card
    This figure shows removing and installing the LOM riser card.
    1. LOM riser card
    2. screw (2)
    3. standoff (2)
    4. connector on the system board

Next steps

  1. Install the LOM riser card.

  2. Follow the procedure listed in the After working inside your system section.
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\