CAUTION: Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
CAUTION: To prevent
damage to the SSDs and the SSD backplane, you must remove the SSD
carriers from the sled before removing the SSD backplane.
CAUTION: You
must note the bay number of each SSD and temporarily label them before
removal so that you can reinstall them into their original bays.
Follow the safety guidelines listed in the Safety
instructions section.
Follow the procedure listed in the Before working
inside your system section.
Remove the SSD carrier(s).
Keep the Phillips #2 screwdriver
ready.
Steps
Loosen the two captive screws on the backplane
touch points that secure the SSD backplane to the SSD cage.
Holding the backplane at the touch points,
lift the SSD backplane till it disengages from the connector on the
system board.
Lift the backplane away from the SSD cage.
Next steps
Install the SSD backplane.
Install the SSD carrier(s).
Follow the procedure listed in the After working inside
your system section.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\