Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge VRTX Enclosure Owner's Manual

Removing an integrated storage controller card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. If installed, remove the front bezel.
  2. Turn off the server modules using the operating system commands or the CMC.
  3. Turn off the enclosure, including any attached peripherals, and disconnect the enclosure from the electrical outlet and peripherals.
  4. To reduce the chassis weight, remove the following (if required):
    1. hard drives
    2. server modules
    3. power supply units
  5. If applicable, rotate the system feet inward and lay the system on its side on a flat stable surface, with the cover release latch side on top.
  6. Open the system.
  7. Push down the two release levers at the edge of the card to disengage the card from the connector.
  8. Orient the card so that the other end of the card disengages from the storage-controller card holder on the system board.
    Figure 1. Removing and installing an integrated storage controller card
    The figure shows removing and installing an integrated storage controller card.
    1. release levers (2)
    2. storage-controller card holder
    3. storage controller card
    4. touch points (2)
    5. storage-controller card connector on the system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\