Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge VRTX Enclosure Owner's Manual

PDF

Installing a server module

Prerequisites

Your system supports server modules that are specifically configured for the PowerEdge VRTX enclosure, and can be identified by a label marked PCIe on the top of the server module.
NOTE: To install full-height server module(s), you must remove the server module partitions. For more information, see Removing The Server Module Partitions.

Steps

  1. If you are installing a new server module, remove the plastic cover(s) from the I/O connector(s) and save for future use.
  2. If applicable, configure the server module. For more information, see Configuring A Server Module.
  3. Orient the server module so that the module handle is on the left side of the server module.
  4. Align the server module with the server module slot and guide rails on the enclosure.
  5. Using both hands, slide the server module into the enclosure until the module release handle engages and locks the server module in place.
  6. If applicable, reinstall the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\