CAUTION: Many
repairs may only be done by a certified service technician. You should
only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service
and support team. Damage due to servicing that is not authorized by
Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
Steps
Route the LCD module cable properly to prevent it from
being pinched or crimped.
Align the slot on the cable holder with the metal standoff
on the chassis.
Slide the cable holder into the chassis, and install the
screw to secure it to the chassis.
Connect the LCD module cable to the new control panel.
Align the slots on the sides of the control panel with
the metal standoffs on the chassis.
Slide the control panel into the chassis.
Ensure that the LCD module cable is not pinched or crimped.
Install the three screws to secure the control panel to
the chassis.
Reconnect the control panel cable to the system board.
Reinstall the cooling fan assembly.
Reinstall the cooling shroud.
Close the system.
If applicable, place the system upright on a flat, stable
surface and rotate the system feet outward.
Reinstall the hard drives.
Reinstall the server modules.
Reconnect the enclosure to its electrical outlet and turn
the enclosure on, including any attached peripherals.
Turn on the server modules using the operating system commands
or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\