Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.

Dell PowerEdge VRTX Enclosure Owner's Manual

Installing the low profile expansion card divider unit

About this task

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

Steps

  1. Align the expansion card divider unit with the guide pin on the system board.
  2. Lower the divider unit into the chassis.
    When properly seated, the screw holes on the divider unit align with the screw holes on the chassis.
  3. Install the screws to secure the divider unit to the chassis.
  4. If applicable, reinstall the expansion cards.
  5. Close the system.
  6. If applicable, place the system upright on a flat, stable surface and rotate the system feet outward.
  7. If removed, reinstall the hard drives, server modules, and power supply units.
  8. Reconnect the enclosure to its electrical outlet and turn the enclosure on, including any attached peripherals.
  9. Turn on the server modules using the operating system commands or the CMC.
  10. If applicable, install the front bezel.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\