Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

iscsi target port

Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication is monitored.

Syntax

iscsi target port [ tcp-port-2...tcp-port-16]ip-address [ ip-address]

To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.

Parameters

tcp-port-2...tcpport- 16	Enter the tcp-port number of the iSCSI target ports. The `tcp-port-n` is the TCP port number or a list of TCP port numbers on which the iSCSI target listens to requests. Separate port numbers with a comma. The default is 860, 3260.
ip-address	(Optional) Enter the ip-address that the iSCSI monitors. The ip-address specifies the IP address of the iSCSI target.

Defaults

860, 3260

Command Modes

CONFIGURATION

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module

Usage Information

You can configure up to 16 target TCP ports on the switch in one command or multiple commands.

When you use the no iscsi target port command and the TCP port you wish to delete is one bound to a specific IP address, the IP address value must be included in the command.