Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

mac-address-table static (for Multicast MAC Address)

For multicast mode of network load balancing (NLB), configure a static multicast MAC address, associate the multicast MAC address with the VLAN used to switch Layer 2 multicast traffic, and add output ports that will receive multicast streams on the VLAN. To delete a configured static multicast MAC address from the MAC address table on the router, enter the no mac-address-table static multicast-mac-address command.

Syntax mac-address-table static multicast-mac-address multicast vlan vlan-id range-output { single-interface | interface-list | interface-range }

To remove a MAC address, use the no mac-address-table static multicast-mac-address output interface vlan vlan-id command.

Parameters
multicast-mac-address Enter the 48-bit hexadecimal address in nn:nn:nn:nn:nn:nn format.
multicast Enter a vlan port to where L2 multicast MAC traffic is forwarded.
  • NOTE: Use this option if you want multicast functionality in an L2 VLAN without IGMP protocols.
output interface For a multicast MAC address, enter the keyword output then one of the following interfaces for which traffic is forwarded:
  • For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
output-range interface For a multicast MAC address, enter the keyword output-range then one of the following interfaces to indicate a range of ports for which traffic is forwarded:
  • For a Port Channel interface, enter the keywords port-channel then a number. The range is from 1 to 128.
  • For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
vlan vlan-id Enter the keyword vlan then a VLAN ID number from 1 to 4094.
Defaults Not configured.
Command Modes CONFIGURATION
Supported Modes Full–Switch
Command History
Version Description
9.9(0.0) Introduced on the FN IOM.
9.3(0.0) Added support for multicast MAC address on the MXL platform.
Example (Multicast) mac-address-table static 01:00:5E:01:00:01 {multicast vlan 2 output—range Te 0/2,Te 0/3}

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\