Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Dell Financial Services Premier Sign In Partner Program Sign In
Contact Us

Your Dell.com Carts

Dell PowerEdge C6320p Owner's Manual

PDF

Power supply units

NOTE: Using configurations higher than indicated in the table may change the power supply units (PSU) mode to non-redundant. In non-redundant mode, if the power requirement exceeds the installed system power capacity, the BIOS will throttle the processors performance. Also, when Processor Power Capping is enabled, processor throttling occurs on configurations that exceed the cap value.
NOTE: Both the PSUs are hot swappable if the system has the power throttling feature enabled.

The following table lists the maximum supported configurations where power supply unit (PSU) redundancy is guaranteed:

Table 1. Supported PSU configurations for non fabric processorsThis table describes about PSU supported configuration for non fabric processors.
PSU Sled configuration
1400 W Supports up to 215 W processor, three hard drives, and four memory modules per system board (Sled with Mellanox ConnectX-4 embedded controller).
Supports up to 215 W  processor, four hard drives, and four memory modules per system board (Sled without Mellanox ConnectX-4 embedded controller).
Supports up to 215 W processor, two hard drives, and six memory modules per system board (Sled without Mellanox ConnectX-4 embedded controller).
1600 W Supports up to 245 W processor, two hard drives, and six memory modules per system board (Sled with Mellanox ConnectX-4 embedded controller).
Supports up to 245 W processor, four hard drives, and four memory modules per system board (Sled with Mellanox ConnectX-4 embedded controller).
Supports up to 245 W  processor, six hard drives, and four memory modules per system board (Sled without Mellanox ConnectX-4 embedded controller).
Supports up to 245 W processor, three hard drives, and six memory modules per system board (Sled without Mellanox ConnectX-4 embedded controller).
Table 2. PSU supported configurations for fabric processorsThis table describes about PSU supported configurations for fabric processors.
PSU Sled configuration
1400 W Supports up to 230 W processor, two hard drives, and four memory modules per system board
Support up to 230 W processor, four hard drives, and two memory modules per system board
1600 W Support up to 260 W processor, two hard drives, and six memory modules per system board
Support up to 230 W processor, four hard drives, and four memory modules per system board

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\