- Notes, cautions, and warnings
- Before working inside your computer
- After working inside your computer
- Removing the base cover
- Replacing the base cover
- Removing the battery
- Replacing the battery
- Removing the solid-state drive
- Replacing the solid-state drive
- Removing the wireless card
- Replacing the wireless card
- Removing the speakers
- Replacing the speakers
- Removing the coin-cell battery
- Replacing the coin-cell battery
- Removing the heat sink
- Replacing the heat sink
- Removing the battery-status light cable
- Replacing the battery-status light cable
- Removing the touch pad
- Replacing the touch pad
- Removing the I/O-board cable
- Replacing the I/O-board cable
- Removing the I/O board
- Replacing the I/O board
- Removing the keyboard-controls board
- Replacing the keyboard-controls board
- Removing the display assembly
- Replacing the display assembly
- Removing the system board
- Replacing the system board
- Removing the power-adapter port
- Replacing the power-adapter port
- Removing the fan
- Replacing the fan
- Removing the keyboard
- Replacing the keyboard
- Removing the palm rest
- Replacing the palm rest
- Flashing the BIOS
- Getting help and contacting Dell
XPS 13 Service Manual
Procedure
- Slide the palm-rest assembly under the display hinges and align the screw holes on the palm-rest assembly with the screw holes on the display hinges.
- Replace the screws that secure the palm-rest assembly to the display hinges.
- Close the palm-rest assembly.
- Route the display cable through the routing guides on the fan.
- Align the screw hole on the display cable with the screw hole on the I/O board.
- Replace the screw that secures the display cable to the I/O board.
- Connect the media-card reader cable to the I/O board.
- Adhere the tapes that secure the display cable to the fan and the I/O board.
- Connect the display cable to the system board.
- Align the screw holes on the display-cable bracket with the screw holes on the system board.
- Replace the screws that secure the display-cable bracket to system board.
- Adhere the tape over the display-cable bracket.
- Connect the wireless-card cables to the wireless card.
- Align the screw hole on the wireless-card bracket with the screw hole on the system board.
- Replace the screw that secures the wireless-card bracket to the system board.
- Adhere the tape that secures the antenna cables to the system board.
- Connect the touch-screen cable (optional) and camera cable to the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\