Omitir para ir al contenido principal
Cerrar

Bienvenido a Dell

Mi cuenta
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.
Iniciar sesión Crear una cuenta Clientes Premier Iniciar sesión en el programa para partners
Contáctenos

Dell PowerEdge R330 Owner's Manual

PDF

Installing the LCD control panel assembly

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.

  1. Follow the safety guidelines listed in Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.
  3. Keep the Phillips #2 screwdriver ready.

Steps

  1. Align the tabs on the control panel with the notches on the chassis.
  2. Route the LCD cable through the cable retention clip.
  3. Push the control panel toward the chassis until it snaps into place.
  4. Align and install the LCD control panel board.
  5. Secure the board in place with screws.
    Figure 1. Installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis
    This figure shows installing the LCD control panel—four 3.5-inch hot swappable hard drive chassis.

    1. LCD control panel

    2. notches (6)

    3. display module cable retention clip
    4. display module cable
    5. tabs on the LCD control panel (6)
    Figure 2. Installing the LCD control panel board—four hard drive chassis
    This figure shows installing the LCD control panel board.
    1. screw (2)
    2. control panel connector cable
    3. display module cable
    4. LCD control panel board
    5. USB connector cable
    6. standoff on the chassis (2)

Next steps

Follow the procedure listed in the After working inside your system section.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"