Omitir para ir al contenido principal
  • Hacer pedidos rápida y fácilmente
  • Ver pedidos y realizar seguimiento al estado del envío
  • Cree y acceda a una lista de sus productos
  • Administre sus sitios, productos y contactos de nivel de producto de Dell EMC con Administración de la empresa.

Dell PowerEdge R330 Owner's Manual

Removing a 3.5-inch hard drive adapter from a 3.5-inch hot swappable hard drive carrier

Prerequisites

  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Keep the Phillips #2 screwdriver ready.
  3. Remove the 3.5-inch hot swappable hard drive carrier from the system.

Steps

  1. Remove the screws from the rails on the 3.5-inch hot swappable hard drive carrier.
  2. Lift the 3.5-inch hard drive adapter out of the 3.5-inch hot swappable hard drive carrier.
    Figure 1. Removing a 3.5 inch hard drive adapter from a hard drive carrier.
    This figure shows removing a 3.5 inch hard drive adapter from a hard drive carrier.
    1. 3.5-inch hot swappable hard drive carrier
    2. screw (5)
    3. 3.5-inch hard drive adapter
    4. 2.5-inch hot swappable hard drive

Next steps

Remove the 2.5-inch hot swappable hard drive from a 3.5-inch hard drive adapter.


Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"