Dell PowerVault MD 32XX/36XX Series Storage Arrays CLI Guide

PDF

Set Storage Array Learn Cycle

Description

This command sets the learn cycle for the battery backup unit. The learn cycle enables the MD storage management software to predict the remaining battery life. Learn cycles run at set intervals and store the results for software analysis.

Syntax

set storageArray learnCycleDate
                                 (daysToNextLearnCycle=
                                 numberOfDays |
                                 day=
                                 dayOfTheWeek) time=
                                 HH:MM

Parameters

Parameter	Description
`daysToNextLearnCycle`	Valid values are `0` through `7`, where, `0` is immediately and `7` is in seven days. The `daysToNextLearnCycle` parameter takes place up to seven days after the next scheduled learn cycle.
`day`	Valid values for the day parameter include the days of the week. Setting the day causes the next learn cycle to be scheduled on the specified day, after the currently scheduled learn cycle.
`time`	The time in 24-hour format; for example 8:00 a.m. is entered as 08:00. Nine o’clock p.m. is entered as 21:00, and 9:30 p.m. is entered as 21:30.

NOTE: You can set the learn cycle to occur only once during a seven-day period. The time parameter selects a specific time that you want to run the learn cycle. If a value is not entered, the command uses a default value of 00:00 (midnight). If the day and time specified are in the past, the next learn cycle takes place on the next possible day specified.