- Notes, cautions, and warnings
- Summary of Revisions
- Introduction
- Getting Started: Learning INI File Basics
- Parameters for WNOS INI Files Only
- Parameters for WNOS INI, {username} INI, and $MAC INI Files
- Connect Parameter: Options
- TimeZone Parameter: Values
- Best Practices: Troubleshooting and Deployment Examples
Reference Guide Dell Wyse ThinOS Release 8.3.1 – INI Files
Parameters for WNOS INI Files Only
This chapter provides the supported parameters that you can use in a wnos.ini file.
-
NOTE:
For information to help you construct and use the supported INI files, see Getting Started Learning INI File Basics .
Parameters in Table 4 can only be used in a wnos.ini file; they cannot be used in a {username}.ini file.
-
IMPORTANT:
The underlined value for a parameter is the default value. Some parameters also have options shown within brackets [ ]. If an option has an underlined default value, that option and default value will automatically be used with the parameter; options without underlined values can also be used if you want to, but are not automatically used with the parameter.
In addition, when using parameters and options, you can leave the default value or change it to another value shown. For example, in the following case where:
ParameterX={ yes, no}
[Option1={ 0, 1}]
[Option2={1, 2, 3, 4}]
If you use ParameterX, then Option1 and its default value 0 will automatically be used as Option1 has an underlined default value of 0. You can still use Option2 if you want to, however, Option2 is not automatically used with the parameter as Option2 does not have an underlined default value.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"