CAUTION:Many repairs may only
be done by a certified service technician. You should only perform
troubleshooting and simple repairs as authorized in your product documentation,
or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that are
shipped with your product.
Steps
Align the slots on the mounting ears with
the metal tabs on the chassis.
When properly aligned, the screw holes on
the mounting ears align with the screw holes on the chassis.
Attach the screws to secure the mounting ears
to the chassis.
To install the top mounting ear:
Route the LCD cable properly to prevent
it from being pinched or crimped.
Align the slot on the cable holder with
the metal standoff on the chassis, and slide the holder into the chassis.
Install the screw to secure the cable holder
to the chassis.
Reconnect the LCD module cable to the control
panel.
Slide the control panel into the chassis
and install the screws to secure the panel to the chassis.
Reinstall the following:
system top cover
PCIe cage door
Reinstall the system base cover.
Close the system.
If applicable, reinstall the wheel assembly
and power cable retention bracket.
Place the system upright on a flat, stable
surface.
If the wheel assembly is not installed, rotate
the system feet outward.
If removed, reinstall the hard drives, server
modules, and power supply units.
Reconnect the enclosure to its electrical outlet
and turn the enclosure on, including any attached peripherals.
Turn on the server modules using the operating
system commands or the CMC.
If applicable, install the front bezel.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\